Default configuration for HP Smart Array P410i

[ArtBaldini]

I have several HP G6 servers, DL360s and DL380s. When I would delete the configuration on the P410i controller and reboot the server it would give me 3 options, F8 to enter config mode, F7 to accept the default config, or escape to skip the config and continue. If I did nothing, it would automatically use F7 and put a default configuration based on the number of drives attached to the controller.

Recently I have noticed a change in the behavior. On some of my servers the controller does not load the default, and it doesnt even give the option. I have controllers at FW version 2.50 that work the old way, and others that dont, so I have no clue what the difference is, or where to even start looking.

Thanks