Disk Enclosures
cancel
Showing results for 
Search instead for 
Did you mean: 

Diagnostics for EVA3000

SOLVED
Go to solution
David Ryan_3
Occasional Advisor

Diagnostics for EVA3000

Hi,

Is there a procedure/document that outlines a diagnostic process for an EVA3000? We have one that has had a few (apparently) unconnected errors (disk fault, power fault) and I would like to do a general health check on the array, if possible.

Thanks in advance.
4 REPLIES
Mike Reznak
Trusted Contributor
Solution

Re: Diagnostics for EVA3000

Hi,

from admin point of view, all currently odd things should be visible in Command View. All yellow or red parts (marked with exclamation mark) aren't ok.

You can examine Management Agent Event Log, Controller Event log and Controller Termination Event Log, where all odd things which have happend should be found. Click on desired EVA in CV and choose [View Events] in right part of window.

I don't know if some health check procedure exists, have never used any.

Mike
...and I think to myself, what a wonderful world ;o)
Ivan Ferreira
Honored Contributor

Re: Diagnostics for EVA3000

You can also install and configure WEBES, or set SNMP traps in command view.
Por que hacerlo dificil si es posible hacerlo facil? - Why do it the hard way, when you can do it the easy way?
Uwe Zessin
Honored Contributor

Re: Diagnostics for EVA3000

I think there is something described in the manual that describes the firmware upgrades. If the array isn't under continuous monitoring and reporting to HP; I would have the controller logs examined by the service center.

.
David Ryan_3
Occasional Advisor

Re: Diagnostics for EVA3000

Thank you.