Disk Enclosures
cancel
Showing results for 
Search instead for 
Did you mean: 

EMS alert with MSA1000 / hpux11iv2

jfsardon
Occasional Contributor

EMS alert with MSA1000 / hpux11iv2

How can I do to have hpux EMS alert when I have a pb on the MSA1000 (FC) ?
I have nothing (syslog, etc..) when I have a degraded RAID (ie I pull a disk from the MSA array).
2 REPLIES
Torsten.
Acclaimed Contributor

Re: EMS alert with MSA1000 / hpux11iv2

Read the EMS alert and try to find the meaning of this (you did not post it - you cannot expect an answer ...) and connect to the CLI and get the status.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Andrew Merritt_2
Honored Contributor

Re: EMS alert with MSA1000 / hpux11iv2

Hi,
Can you check which version of the OnlineDiags you have installed? Just run 'cstm' and see the version number. If it's recent, you should have 'msamon' running, which should report problems with the MSA1000.

See http://www.docs.hp.com/en/diag/stm/stm_upd.htm#table for the versions, and more about msamon here - http://docs.hp.com/en/diag/ems/msamon.htm and here - http://docs.hp.com/en/diag/ems/emd_msamon.htm

Andrew