Skip to ContentSkip to Footer
Start of content
- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- Disk Enclosures
- >
- EMS does not notify when VA7100 has non-CRITICAL p...
Disk Enclosures
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
-
- Forums
-
Blogs
- Alliances
- Around the Storage Block
- Behind the scenes @ Labs
- HPE Careers
- HPE Storage Tech Insiders
- Infrastructure Insights
- Inspiring Progress
- Internet of Things (IoT)
- My Learning Certification
- OEM Solutions
- Servers: The Right Compute
- Shifting to Software-Defined
- Telecom IQ
- Transforming IT
- Infrastructure Solutions German
- L’Avenir de l’IT
- IT e Trasformazione Digitale
- Enterprise Topics
- ИТ для нового стиля бизнеса
- Blogs
-
Quick Links
- Community
- Getting Started
- FAQ
- Ranking Overview
- Rules of Participation
- Contact
- Email us
- Tell us what you think
- Information Libraries
- Integrated Systems
- Networking
- Servers
- Storage
- Other HPE Sites
- Support Center
- Enterprise.nxt
- Marketplace
- Aruba Airheads Community
-
Forums
-
Blogs
-
InformationEnglish
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
12-13-2001 12:37 PM
12-13-2001 12:37 PM
EMS does not notify when VA7100 has non-CRITICAL problems
I am trying to figure out why EMS does not notify me when my VA7100 has non-CRITICAL problems. I have configured RemoteMonitor to report all problems, other than INFORMATION, via EMAIL to root and to syslog. I have also configured RemoteMonitor to poll every five minutes. But it only reports CRITICAL problems and it can take over half an hour to get the email. My test for non-CRITICAL problems is to pull out one of the power cords or to disconnect a controller. My test for CRITICAL problems is to shut off the VA7100.
I am running HP-UX 11.11 on a J5000.
EMS is at A.26.00
CommandView SDM is at 01.02
the VA7100 controller firmware is at HP13
Thanks in advance for any help,
Aaron
I am running HP-UX 11.11 on a J5000.
EMS is at A.26.00
CommandView SDM is at 01.02
the VA7100 controller firmware is at HP13
Thanks in advance for any help,
Aaron
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
End of content
United States
Hewlett Packard Enterprise International
Communities
- Communities
- HPE Blogs and Forum
© Copyright 2019 Hewlett Packard Enterprise Development LP