Disk Enclosures
cancel
Showing results for 
Search instead for 
Did you mean: 

ERRO EVA4400 Slave Only

JuanCG
Super Advisor

ERRO EVA4400 Slave Only

Hello everyone, I have a problem with an EVA4400 (2C 1D), the case is that the initialize one controller connected, and when 'connect the second controller now can not manage.

In CV8.0 I get the WWN - Only slave and right:

Operation Failed
Status code: 8100

I tried to restart, boot to the one you had before with nothing holding me but continues to do the same.

I can help?
3 REPLIES
Víctor Cespón
Honored Contributor

Re: ERRO EVA4400 Slave Only

Command View only talks to the master controller. If that controller is not working, or not connected, you get that message.
Check the controller status from WOCP, try to reset it.
JuanCG
Super Advisor

Re: ERRO EVA4400 Slave Only


I tried, I did not sign but I get nothing.
Is there any way to inicalizarla or something?

What if it started with a single controller?
Víctor Cespón
Honored Contributor

Re: ERRO EVA4400 Slave Only

Can you restart or power it off from the WOCP?
Try to remove it from the enclosure and insert it again.
The EVA can work with only one controller, there are two for redundancy.