- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- Disk Enclosures
- >
- ESX 3.0 command line and DMX arrays
Disk Enclosures
1752700
Members
5913
Online
108789
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-24-2008 04:42 PM
01-24-2008 04:42 PM
ESX 3.0 command line and DMX arrays
Is there a command line for ESX 3.0 to show LUN mapping for storage arrays like XP and DMX-3?
I am looking for a command similar xpinfo or inq.
Points will be awarded for good responses.
I am looking for a command similar xpinfo or inq.
Points will be awarded for good responses.
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-29-2008 04:15 AM
01-29-2008 04:15 AM
Re: ESX 3.0 command line and DMX arrays
Hi,
If you are using XP, then try to use xpinfo for linux, since ESX is based on RedHat. I don't have it, but perhaps you can contact HP for this.
Check this thread: http://forums12.itrc.hp.com/service/forums/questionanswer.do?admit=109447627+1201608799638+28353475&threadId=944743
Regards,
Sandy
If you are using XP, then try to use xpinfo for linux, since ESX is based on RedHat. I don't have it, but perhaps you can contact HP for this.
Check this thread: http://forums12.itrc.hp.com/service/forums/questionanswer.do?admit=109447627+1201608799638+28353475&threadId=944743
Regards,
Sandy
I never think of the future. It comes soon enough.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP