Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
Disk Enclosures
cancel
Showing results for 
Search instead for 
Did you mean: 

EVA 4400 Returns a status code 22 and 83

Stefano Meroni
Occasional Visitor

EVA 4400 Returns a status code 22 and 83

Hello.
We're trying to change the IP address of the anagement port to an EVA4000 but we got this errors info...

Error updating Management Module configuration data on the Storage Cell.
Status code: 22

Error updating Management Module configuration data on the Storage Cell.
Status code: 83

Any way, where we can found the EVA 4000 Error codes reference? We surfed a lot without success.

thankyou

Stefano
4 REPLIES
Víctor Cespón
Honored Contributor

Re: EVA 4400 Returns a status code 22 and 83

Try to press the reset button on the management module 5 seconds, this should reset the IP to 192.168.0.1

Update controllers and management module to latest firmware. I have seen cases where this solved the issue

The IP cannot be of the range 10.XXX.XXX.XXX
Stefano Meroni
Occasional Visitor

Re: EVA 4400 Returns a status code 22 and 83

Hi,
it seems to be a non correct configuration of the two fabric switches becouse connecting directly to the eva from the server all goes ok.

We enabled the ports on the switches but we still need to perform some points I suppose.

Can you redirect us to the correct topic?

Thankyou in advance!

Stefano
Stefano Meroni
Occasional Visitor

Re: EVA 4400 Returns a status code 22 and 83

Ok, we managed in configuring the fabric switch too.

Thankyou
Stefano Meroni
Occasional Visitor

Re: EVA 4400 Returns a status code 22 and 83

After performing a new switches configuration all worked good!

Stefano