Disk Enclosures
cancel
Showing results for 
Search instead for 
Did you mean: 

Re: EVA4000 moving EMU cable on-line

 
SOLVED
Go to solution
Regular Advisor

Re: EVA4000 moving EMU cable on-line

I have just moved the Y cable from EMU ID#3 to ID#4 without problem, CV sees the controller pair as it.

But with the two enclosures moved from ID#2 to ID#3, and from ID#1 to ID#2, they stay with ID#2 and ID#1

I tried the Locate On the two enclosures, but one is staying On, and flashing continuously.

Is there a possibility to recover this situation without a EVA shutdown
Honored Contributor

Re: EVA4000 moving EMU cable on-line

Hi,
EAB related "issues" can take a while to be "fixed" in CV. Leave it for a while, maybe a couple of hours, and it may resolve itself, assuming that the shelves now have the correct numbers that you have connected them to.
If not, as suggested above, you may well have to reboot one or both ctrls.
Mark...
if you have nothing useful to say, say nothing...
Regular Advisor

Re: EVA4000 moving EMU cable on-line

Really, the Leds shows ID#3 and ID#2 on the 2 enclosures, but CV see ID#2 and ID#1.

And the locate problem is resolved after several Locate on / Locate off.

I will wait until next week, and a planned shutdown of EVA is scheduled if not resolved.

Regular Advisor

Re: EVA4000 moving EMU cable on-line

Right after complete shutdown of EVA4000
Regular Advisor

Re: EVA4000 moving EMU cable on-line

N/A