HPE Community
Disk Enclosures
1752809 Members
6156 Online
108789 Solutions
New Discussion

Enabling NCQ Native Command Queuing on P400 controller

 
beovax
Advisor

‎08-04-2009 06:06 AM

‎08-04-2009 06:06 AM

Enabling NCQ Native Command Queuing on P400 controller

I am trying to make sure I have enabled NCQ the quick specs say

"For NCQ to be enabled, it must be
supported and turned on in the controller and in the hard drive itself"

I have run the ADU and the controller reports that NCQ is supported the Disks say that NCQ is supported and enabled. What worries me is that controller doesnt report NCQ enabled - just supported.

Does this mean it is enabled or is there still a setting on the controller I need to enable?

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.