HPE Community
Disk Enclosures
1751703 Members
4950 Online
108781 Solutions
New Discussion юеВ

Expanding Array using Smart Array 5300

 
Daniel Hatter
New Member

тАО10-18-2005 09:42 AM

тАО10-18-2005 09:42 AM

Expanding Array using Smart Array 5300

One of my drives went down over the past few days and after replacing it the RAID failed to rebuild. I am using Raid 5 across 3 18gb drives. The ACU still reports the HardDrive SCSI ID as failed with the new drive in place and I see no expansion or rebuild option in the ACU. The ACU does however show the new harddrives. I have a backup but don't want to mess around with it too much because its my webserver.
0 Kudos
Reply
2 REPLIES 2
Steven Clementi
Honored Contributor

тАО10-18-2005 09:59 AM

тАО10-18-2005 09:59 AM

Re: Expanding Array using Smart Array 5300

Daniel:

What this a drive that was in another system? or just a standby on the shelf?

Do you have another one to swap?


Steven
Steven Clementi
HP Master ASE, Storage, Servers, and Clustering
MCSE (NT 4.0, W2K, W2K3)
VCP (ESX2, Vi3, vSphere4, vSphere5, vSphere 6.x)
RHCE
NPP3 (Nutanix Platform Professional)
0 Kudos
Reply
Daniel Hatter
New Member

тАО10-18-2005 10:48 AM

тАО10-18-2005 10:48 AM

Re: Expanding Array using Smart Array 5300

Yes this drive was tested good in another system. This drive also works fine in any other slot in my hotswap other than ID2
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.