- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- Disk Enclosures
- >
- FC60 controller in Passive mode
Disk Enclosures
1753907
Members
9046
Online
108810
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-05-2000 01:22 PM
01-05-2000 01:22 PM
FC60 controller in Passive mode
In case anyone has reconfigured or otherwise confused their FC60 array (A5277A
Surestore E Disk Array) such that one or both of its controllers have gone
"passive" there is an undocumented (at least so far) command to reset them to
"active" state. It is:
ammgr -c AA
Surestore E Disk Array) such that one or both of its controllers have gone
"passive" there is an undocumented (at least so far) command to reset them to
"active" state. It is:
ammgr -c AA
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-05-2000 01:33 PM
01-05-2000 01:33 PM
Re: FC60 controller in Passive mode
OOPS!
That command needs the array id after it as usual. not sure why "arrayid"
surrounded by arrows as used in the users guide did not post on the first
message...let me use parenthesis instead:
ammgr -c AA (arrayid)
That command needs the array id after it as usual. not sure why "arrayid"
surrounded by arrows as used in the users guide did not post on the first
message...let me use parenthesis instead:
ammgr -c AA (arrayid)
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP