Disk Enclosures
1745814 Members
4114 Online
108722 Solutions
New Discussion юеВ

Force Unit Access

 

Force Unit Access

Can someone please tell me how to change "Force Unit Access Response" in the 12H autoraid configuration? It is set to 0 and I want to change it to 2. I have the Sys Admin manual but it isn't helping me regarding this particular setting. I have tried changing the Simplified Resiliency but this does not affect the Force Unit Access setting.
7 REPLIES 7
David Navarro
Respected Contributor

Re: Force Unit Access

I have seen in admin manual that this parameter takes effect when write cache is enabled. Do you have warite cache enabled?.

Re: Force Unit Access

Yes, write cache is enabled. I thought that would change it also but it didn't.
David Navarro
Respected Contributor

Re: Force Unit Access

Hi, I see data resiliency mode in manual. Try to change it with arraymgr command, and you can see if that value has been change or not.

Re: Force Unit Access

I changed the resiliency to Secure, High Performance, etc but nothing is changing the Force Unit Access.
David Navarro
Respected Contributor

Re: Force Unit Access

Last Idea I have is check your firmware version, maybe is an older one. I don't know which version are actually running in that boxes.

Re: Force Unit Access

Firmware is HP62
David Navarro
Respected Contributor

Re: Force Unit Access

HI. That is the last F/W release in HP web. Is dated on Oct-2000.