Disk Enclosures
cancel
Showing results for 
Search instead for 
Did you mean: 

Hot Swap drive will not rebuild. Stuck in queue state ADU attached

SOLVED
Go to solution
Lionelc
Occasional Contributor

Hot Swap drive will not rebuild. Stuck in queue state ADU attached

Hoping someone could assist me with my problem. Have Compaq ML530 running Netware6.5. A drive failed a couple weeks ago, I replaced it and it starts to rebuild then stops and goes to queue state. I upgraded all the firmware, PSP, but still will not complete. I ran ADU this morning have attached for review.

Thanks
2 REPLIES
skris
Trusted Contributor
Solution

Re: Hot Swap drive will not rebuild. Stuck in queue state ADU attached

Hi Lionel,
The Drive @ Location 10 has I/O errors, causing the rebuild to have failed twice already.

Timestamps:
09-22-2008 17:07:41
09-24-2008 08:16:06
> Rebuild has failed Twice already :(

Logical Drive Status :Rebuild aborted due to read error, logical drive 00000001.

Replacement drive 11 Error drive 10.

Now chances are the rebuild will not complete at all. Best bet is to restore from a backup to save time. The Drive 10 is the one failing and needs to be replaced too.

Cheers!
Shiva
Roy Main
Valued Contributor

Re: Hot Swap drive will not rebuild. Stuck in queue state ADU attached

What you may want to try, is to put the old "failed" drive back in.

It may go green for a while enabling you to get a backup if you don't already have one.

It the drive works for a while, you can pull the drive that has "failed read recover" errors. What's happending is that one of the other drives has bad parity data. Once that one rebuilds, replace the original "failed" drive. Then your array will be ok.