Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
Disk Enclosures
cancel
Showing results for 
Search instead for 
Did you mean: 

How to connect onto the MSA 2000 model 2012fc ?

lisa83
Occasional Visitor

How to connect onto the MSA 2000 model 2012fc ?

How do I connect onto the MSA 2000, I have a serial connection for my laptop and a RJ45 for the MSA. but do not know the IP address of the MSA. Can I find the IP address of the MSA ??
many thanks
1 REPLY
Patrick Terlisten
Honored Contributor

Re: How to connect onto the MSA 2000 model 2012fc ?

Hello Lisa,

you can controller A with the ip address 10.0.0.2 and controller B with 10.0.0.3. The subnetmask is 255.255.255.0. You can connect the controller with a serial connection and the parameters 115200 baud, 8 data bits, no parity, 1 stop bit and no flow control. After connecting to the serial CLI you can set a new ip address with the command:

# set network-parameters ip 172.16.99.10 netmask 255.255.255.0 gateway 172.16.99.1 controller a

or

# set network-parameters ip 172.16.99.11 netmask 255.255.255.0 gateway 172.16.99.1 controller b

Both controllers need different ip addresses. But you can also change the ip over the normal web interface. :)

Hope this helps.

Best regards,
Patrick
Best regards,
Patrick