Disk Enclosures
cancel
Showing results for 
Search instead for 
Did you mean: 

MSA 1000 with HP-UX + ACL problem...

nishith
Frequent Advisor

MSA 1000 with HP-UX + ACL problem...

I am having a problem while setting up ACL in MSA 1000 with hp-ux. I created two LUNs in the MSA. I have two rp3440 servers connected to MSA via, 2/8 Embedded switch. Now both this LUNs are visible to both servers. But now I’m not able to set the ACL for these LUNs. I have doubt in my connection settings.

Show connections:

Connection Name:
Host WWNN = 50060B00-0300CD49
Host WWPN = 50060B00-0300CD48
Profile Name = default
Unit Offset = 0
Controller 1 Port 1 Status = Offline

Connection Name:
Host WWNN = 50060B00-0300CDCA
Host WWPN = 50060B00-0300CDCB
Profile Name = default
Unit Offset = 0
Controller 1 Port 1 Status = Offline

Connection Name: OraTest
Host WWNN = 50060B00-0300CD49
Host WWPN = 50060B00-0300CD48
Profile Name = hp
Unit Offset = 0

Connection Name: OraProd
Host WWNN = 50060B00-0300CDCA
Host WWPN = 50060B00-0300CDCB
Profile Name = hp
Unit Offset = 0

I added two connections using the server WWPN with profile hp. that is also indicated in the unknown connections. But still the unknown connections are still present.

When I set ACL using connection name- Oraprod & Oratest, it accepts. But now none of LUNs are not visible in HP-UX. Can anyone help me out in this regard.
1 REPLY
John Kufrovich
Honored Contributor

Re: MSA 1000 with HP-UX + ACL problem...

Did you assign the units to those servers.

At the cli, issue the cmd
>show acl

This cmd will show if any units have been assigned to those servers.