1748239 Members
3731 Online
108759 Solutions
New Discussion юеВ

MSA 1500

 
Rakesh_26
Advisor

MSA 1500

Please can some one advice me how i can connect to the SAN Switch 2/8V.(MSA 1500).

I want to be able zone the switch. I have only recently purched this.
6 REPLIES 6
Uwe Zessin
Honored Contributor

Re: MSA 1500

The switch has a serial port and an ethernet port. It comes with a special serial cable that is ready for a PC.

Attach to the switch with a terminal emulator (Window's Hyperterm is sufficient) and login to the switch. The default username is "admin" and the default password is "password".

You can use the command line to set up the zoning, but you can also configure the ethernet port. The command is "ipAddrSet" - just hit return and you get prompted, but don't assign an IP address to the FC interface.

After you have set up the IP address, you can connect using "Telnet" or a Web browser.
.
Rakesh_26
Advisor

Re: MSA 1500


Hi

I have tried as suggested. Hoever i have been promted with a "Swd77 Admin"

I can not get any further from this point can you help
Uwe Zessin
Honored Contributor

Re: MSA 1500

swd77:admin>

That's the default prompt. You can now change the IP configuration with "ipaddrset" as I said or do the zoning setup through the command line interface.
.
Ruslan
Respected Contributor

Re: MSA 1500

Rakesh, Uwe completly explain you solution, try to read start up guide which is include with SAN switch shipment.
Rakesh_26
Advisor

Re: MSA 1500

thanks

is there a Gui version to config zone, or is the command line the only option.
Uwe Zessin
Honored Contributor

Re: MSA 1500

Does access from a web browser not count as a GUI?
.