HPE Community
Disk Enclosures
1752570 Members
5087 Online
108788 Solutions
New Discussion юеВ

MSA1000, Linux box does not find the new disk

 
Hasan_9
Regular Advisor

тАО10-24-2005 05:46 AM

тАО10-24-2005 05:46 AM

MSA1000, Linux box does not find the new disk

Hi Everybody,

There is a MSA1000 that I created an array with 4 Disks and one disk as a spare part. Then I assigned all the capacity to a LUN. After rebooting my Linux box, it did not find the new disk. I deleted the LUN and then created a 100MB and assigned all the remaining capacity to another LUN. After rebooting the box, I could see 2 new disks. I tested it again and got the same results. Whenever I created just one LUN with all the capacity Linux does not find the new disk. What is your idea?

Hasan
0 Kudos
3 REPLIES 3
Ivan Ferreira
Honored Contributor

тАО10-24-2005 08:44 AM

тАО10-24-2005 08:44 AM

Re: MSA1000, Linux box does not find the new disk

Please do the test and post the results of cat /proc/scsi/scsi and fdisk -l. Also the result of dmesg.
Por que hacerlo dificil si es posible hacerlo facil? - Why do it the hard way, when you can do it the easy way?
0 Kudos
Hasan_9
Regular Advisor

тАО10-24-2005 11:25 PM

тАО10-24-2005 11:25 PM

Re: MSA1000, Linux box does not find the new disk

If I have a LUN with all the array capacity, fdisk -l shows nothing.However if i created more than one LUN in array, fdisk -l shows all the LUNs correctly
0 Kudos
Hasan_9
Regular Advisor

тАО02-01-2006 10:57 PM

тАО02-01-2006 10:57 PM

Re: MSA1000, Linux box does not find the new disk

I upgraded the firmaware and everything is correct now
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.