Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
cancel
Showing results for 
Search instead for 
Did you mean: 

MSA1000

alex lin_3
Occasional Visitor

MSA1000


I have two rx1610 servers which run hpux 11.23 and direct attach to MSA1000 2/3 Hub module.
There is only one HBA(A6795A)in each rx1610 host.
When I run ioscan ,it can not find the MSA1000,and show below error messages.
vmunix: 0/2/1/0: WARNING: It appears that there are (or were) more than one device with
vmunix: the same address (nport ID) setting of 0x0. One of them will be ignored.
I have upgrade the firmware in MSA1000,but still have the problem.
What next step do I have to do or something configuration did I need to change.
Tks!
6 REPLIES
Peter Mattei
Honored Contributor

Re: MSA1000

Hi

Did you set hard addressing in the MSA controller?

In the HP-UX - MSA1000 manual it says:
FC/AL configurations must enable hard addressing on the MSA1000 controller.
See Array Controller Configuration Settings in the Command Line Interface user guide for instructions.

You find the whole manual here:
http://h20000.www2.hp.com/bc/docs/support/SupportManual/c00096723/c00096723.pdf


Cheers
Peter
I love storage
alex lin_3
Occasional Visitor

Re: MSA1000

Hi,Peter:

I have set hard addressing in the MSA controller yet.
Peter Mattei
Honored Contributor

Re: MSA1000

Alex

Did you also check the remainder of the procedures in the installation guide?

Peter
I love storage
alex lin_3
Occasional Visitor

Re: MSA1000

Hi,Peter:
I have follow the installation procedure,but still have the same problem.
Do I have to add another patches after I haved installed the HP_UX 11.23 OS(Mission Critical default install) for the HBA or MSA1000 Storage?
Tks!
Peter Mattei
Honored Contributor

Re: MSA1000

Sorry, I cannot tell!

Best is to call HP support.

Cheers
Peter
I love storage
alex lin_3
Occasional Visitor

Re: MSA1000

Hi,Peter:
We have solved the problem
In MSA1000 CLI
set the connection profile to hp not default.
It work ok.
Tks!