Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
cancel
Showing results for 
Search instead for 
Did you mean: 

MSA30

Jeffrey F. Goldsmith
Super Advisor

MSA30

I have an MSA30 with a dual bus that is connected to my rp3440-4 server (HP-UX 11.23).  There are twelve 72.8GB hard drives installed into it right now.  I have two more drives on the shelf for hot swaps but now I am considering installing them into the two empty slots.  With that being said I have a few questions about doing this.  When the MSA30 was setup they had set it up as a raid 1-0, stripped six drives on the first bus and then mirrored it with the six drives on the second bus.

 

1.  Once I put the two drives into the empty slots how should i go about adding them into the raid? 

 

2.  Or can I add them to the existing raid?

 

3.  I am also in the process of trying to figure out a way to mirror the raid (vg01) onto my SAN which is a PS6500.

 

Thanks for any help you can give.

1 REPLY
Torsten.
Acclaimed Contributor

Re: MSA30

Could you post an

 

# ioscan -fn

 

I want to know if there is a smart array controller.

 

 

 

Regarding (3) - did you mirror the data to the SAN as suggested?


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!