HPE Community
Disk Enclosures
1753837 Members
9054 Online
108806 Solutions
New Discussion юеВ

Nike 20 Array SP Question

 
SOLVED
Go to solution
Ken Martin_3
Regular Advisor

тАО12-19-2007 02:26 PM

тАО12-19-2007 02:26 PM

Nike 20 Array SP Question

OK so I went into FE mode to check complete configuration and event logs of SP's...

Had an SP that went into service mode (yellow led on) twice. Reseating the SP brought it back up.

Now I can't remember how to exit FE mode.

Any ideas?

Thanks
0 Kudos
3 REPLIES 3
gsb_2
Regular Advisor

тАО12-19-2007 05:21 PM

тАО12-19-2007 05:21 PM

Solution

Re: Nike 20 Array SP Question

Isn't it control P USER?
0 Kudos
Torsten.
Acclaimed Contributor

тАО12-19-2007 10:39 PM

тАО12-19-2007 10:39 PM

Re: Nike 20 Array SP Question

gsb is right.
CTRL p USER (upper case)

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Ken Martin_3
Regular Advisor

тАО12-20-2007 12:08 PM

тАО12-20-2007 12:08 PM

Re: Nike 20 Array SP Question


Exiting FE mode on a Nike 20 Array controller requires Control-P USER

This is when the 'SP' controller is
accessed via the serial port on the
back of the unit.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.