HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Disk Enclosures
cancel
Showing results for 
Search instead for 
Did you mean: 

Not enough Disk Space...

 
H_3
Occasional Advisor

Not enough Disk Space...

Hello,

I have a ML530 server with a SA 5300. I am trying to upgrade Fujitsu 9GB Wide-Ultra3 SCSI drives, model BD009635C3; FW:B21 -> B22

However, I get the following error when trying to flash the firmware, "Not enough space on disk to create file."

I was successful is upgrading the firmware from B17 -> B21.

Any ideas?

Thanks,
H

4 REPLIES
josemaria cr
Regular Advisor

Re: Not enough Disk Space...

Can it be referred to the floppy?

jmc
H_3
Occasional Advisor

Re: Not enough Disk Space...

I hope not. You gave me an idea, so I deleted the other firmware images that were on the diskette. But then I got an error telling me that the CPQINT.OPT could not load. I am stuck here :-(
josemaria cr
Regular Advisor

Re: Not enough Disk Space...

Be sure to generate a good floppy, and try with another floppy, another release?¿? ...

j
H_3
Occasional Advisor

Re: Not enough Disk Space...

Unfortunately, I already tried that.

I have already flashed the firmware once, B17 -> B21, I wonder if these drives only have the capacity to be flashed once. Sounds crazy, but I've seen weirder.