Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
Disk Enclosures
cancel
Showing results for 
Search instead for 
Did you mean: 

P2000 G3 SAS, C3000 and VMware ESXi 4.1 U1

Stef Pap
Occasional Contributor

P2000 G3 SAS, C3000 and VMware ESXi 4.1 U1

Hi all,
I can't see any LUN's that I create on P2000 in ESXi. My configuration is like this:

Hardware
P2000 G3 SAS with dual controllers
c3000 with dual SAS switch connected to P2000 with 2 SAS cables (switch 1/port1 to controller1/port1, switch 2/port1 to controller2/port1}.
2 BL460c G7 with P700m SAS controller on mezanine slot 2

Software
ESXi 4.1 Update 1

What I tried so far:
Updated every device with the latest firmware
On P2000 I created 2 LUNs and presented with explicit mapping to the hosts
On SAS switch, configured multi initiator mode, created a zone with all SAS ports and mapped the 2 blades to that zone.

Any suggestions?
Thank You
1 REPLY
Brian Ray
Occasional Visitor

Re: P2000 G3 SAS, C3000 and VMware ESXi 4.1 U1

Stef,

Late response, probably already got it.

If zoning and everything is cool - check that you are not using a LUN number > 255 - we had trouble with this both on an XP2000 and our P2000.

If this wasn't the problem, could you please update how you resolved your problem.

- Brian.