Rebuilding RAID array in SC10

Pabs_1 · ‎06-06-2007

Hi all,

One of the disk in SC10 was crash, how to rebuild the array in RAID 5 after replacing the disk?

Thanks.

Pabs

Torsten. · ‎06-06-2007

Hi,

may I assume this jbod is connected to a raid4si controller and hp-ux is running?

If there is no hotspare configured, just replace the disk - that's it.

If you have a hotspare configured, it is now part of the RAID. You need to make the new disk the hotspare (using irm tool).

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!

Pabs_1 · ‎07-06-2007

Thanks.

Pabs

Torsten. · ‎07-06-2007

You are welcome.

Remember to read this:

http://forums1.itrc.hp.com/service/forums/helptips.do?#33

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!