Disk Enclosures
1748201 Members
3604 Online
108759 Solutions
New Discussion юеВ

Re: SW EVA4400 dual controller issue

 
dundee
Occasional Advisor

SW EVA4400 dual controller issue

Hello.
I have EVA4400 with dual controller HSV300.
One of the started acting out, showing up or disappearing. So i decide to update firmware.
I've updated 1 controller to 09534000, then i updated Management module to mmp-0001.4200-CR0670.
Now 1st controller is still down and CV 8.0 does not see the array.
Can you guys suggest anything?
as i understand there can be an issue with latest firmware not seeing array or i need to update CV version.

Thanks
10 REPLIES 10
dundee
Occasional Advisor

Re: SW EVA4400 dual controller issue

Also, on the controller LED health light is flashing green. manual says it suppose to be solid. Any ways to diagnose that?
Torsten.
Acclaimed Contributor

Re: SW EVA4400 dual controller issue

Minimum CV version is 9.1, better use version 9.3.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
dundee
Occasional Advisor

Re: SW EVA4400 dual controller issue

I just figured i could run CV from management controller, which i did and i can see array no problems. it is 9.3
So my issue is still my second controller flashing health LED.
and if someone knows how to uninstall CV 8.0, nothing in "add/remove" section, i would appreciate it.
Torsten.
Acclaimed Contributor

Re: SW EVA4400 dual controller issue

The 9.3 installer uninstalls previous versions first, so it should be no longer there.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
dundee
Occasional Advisor

Re: SW EVA4400 dual controller issue

unfortunately it did not, and during install it asked to have previous version removed first.
Now, in 8.0.1 install manual mentions uninstall from disk other than C drive, but it only asks to install latest java and nothing else.
Avenir Voronov
Occasional Advisor

Re: SW EVA4400 dual controller issue

Where are you download mmp-0001.4200-CR0670 ? Could you put it here?
Johan Guldmyr
Honored Contributor

Re: SW EVA4400 dual controller issue

Good to revive the threade :)

The management module firmware can be found in the Command View ISO file - find it on software.hp.com
dundee
Occasional Advisor

Re: SW EVA4400 dual controller issue

HP site is one of the worst to find anything!!!! i don't even remember how i literally stumbled across latest firmware. forum posts, Hp search do absolutely nothing to help.
And now that my hard crashes few weeks ago, I'll be looking for it again :)
Torsten.
Acclaimed Contributor

Re: SW EVA4400 dual controller issue

All the files are unfortunately not at the same place.


Documentation and some software is at

http://www.hp.com/go/bsc

newer controller firmware and CV is at

http://software.hp.com (search for XCS and command view)

Good luck!

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!