Disk Enclosures
cancel
Showing results for 
Search instead for 
Did you mean: 

Software for HP MSA30 with (14) 300GB SCSI and MSA1500 Shelf

Software-FIS
Occasional Visitor

Software for HP MSA30 with (14) 300GB SCSI and MSA1500 Shelf

I need to download the drivers and software for the HP MSA30 with (14) 300GB SCSI and MSA1500 Shelf.

The driver page I found on the HP site directs me to support for the software. This is the HP page : http://bit.ly/cXL27g
4 REPLIES
Torsten.
Acclaimed Contributor

Re: Software for HP MSA30 with (14) 300GB SCSI and MSA1500 Shelf

Usually the MSA30 is either connected to an smartarray controller or an MSA1000/1500, so you only need to driver for the smartarray controller.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Software-FIS
Occasional Visitor

Re: Software for HP MSA30 with (14) 300GB SCSI and MSA1500 Shelf

Its connected to a MSA 1500 actually. Wich in turn is connected to a FC HBA.

But the ACU is not showing it to me. The San Configuration manager is detecting a SGA070601Z storage sub system. But only shows me 12 of the 14 drives to configure. I think I'm missing some software.
Torsten.
Acclaimed Contributor

Re: Software for HP MSA30 with (14) 300GB SCSI and MSA1500 Shelf

If ACU isn't showing the array, you maybe have SSP activated and the access is not allowed from this server. Check from another server or better via serial line.

Other tools most likely show the LUNs, but not the disks!

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Software-FIS
Occasional Visitor

Re: Software for HP MSA30 with (14) 300GB SCSI and MSA1500 Shelf

Fixed :)
I do not have any acl's on the MSA 1500 :

CLI-1>show acl
ACL is disabled. To enable ACL use 'add acl'.

Also doing show disks only showed me 12 disks. Re tried after power cycle . And deleted connections and acl's . Now ACU shows me all disks and I can start using the array :)

Thnx.,