HPE Community
Disk Enclosures
1753774 Members
7005 Online
108799 Solutions
New Discussion юеВ

VA Command View SDM only with read access possibe?

 
Hoffmann Marc
New Member

тАО09-18-2002 01:14 AM

тАО09-18-2002 01:14 AM

VA Command View SDM only with read access possibe?

For a demo I need the VA command view SDM only with read access to show the VA7100 config. Is it possible to configure this only with read access and if it's possible how can I do this?

Thank you for your help!

Regards,
Marc
0 Kudos
Reply
2 REPLIES 2
Vincent Fleming
Honored Contributor

тАО09-18-2002 08:09 AM

тАО09-18-2002 08:09 AM

Re: VA Command View SDM only with read access possibe?

Gruezi!

The current version of Command View SDM does not have multiple levels of security, so no, you can't do it in read-only mode.

If I recall, there is a demo mode (or used to be), but that would not show your configuration... just a sample one.

Tschau!

No matter where you go, there you are.
0 Kudos
Reply
Roger_22
Trusted Contributor

тАО09-19-2002 03:19 PM

тАО09-19-2002 03:19 PM

Re: VA Command View SDM only with read access possibe?

Until a few days ago, you could download a working version of Command View sdm from hp.com. Contact your hp support team, they should be able to get you a copy.

Command View security is set by IP address. If your IP address is granted access then you have read/write permission.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.