VA7100 on warning State

[Toni_4]

Host can´t see VA using ARM commands and SDM.I can configure a new LU accessing to the VA through the rs232 port, but the prompt that it showing all the time is " Warning State> ", using the command dsp -f i saw the warning in main enclosure, dsp -e show me the enclosure type set to main. what it happened

[robert dodd_2]

can you show what the output is from dsp -s form the rs232 port, also from armdsp -i from the hpux prompt.

also the colour of the disk fc and host fc lights on the rear of the enclosure

[Patrick Wallek]

What happens if you do an 'armdiscover' from the host? See if it will rediscover the array.

[Toni_4]

Finally i found a solution myself, catching ideas from other threads and finding some information in internet.Solution: armdiscover couldn´t create DBfile for a bad runing of the Hostagent´s daemons, so any arm command and SDM couldn´t access to VA. And the warning was another problem was causing for bad working of one power supp

[Toni_4]

Thanks to forum.