HPE Community
Disk Enclosures
1752720 Members
5981 Online
108789 Solutions
New Discussion

VA7410 Mismatched Code

 
Greg Cotten
Advisor

‎07-16-2009 08:24 AM

‎07-16-2009 08:24 AM

VA7410 Mismatched Code

When I connect serially to the VA7410, the prompt I get is Mismatched Code>
I have tried to display the two controllers with the dsp -d 1/2 and it returns "Controller Not Present". The command dsp -d returns "No disks present" Yet there are 14 disks in the array. I can't seem to figure this out. I have the host port connected to a HP-UX box and when I try to use CommandView armdiscover, I can see the fibre host port blink so it is talking to it but CommandView cannot see it. Any thoughts?
0 Kudos
Reply
1 REPLY 1
Patrick Terlisten
Honored Contributor

‎07-16-2009 11:57 PM

‎07-16-2009 11:57 PM

Re: VA7410 Mismatched Code

Hello,

where did you get this system? Are both controller okay? Did you an firmware update?

Best regards,
Patrick
Best regards,
Patrick
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.