Skip to ContentSkip to Footer
Start of content
- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- Disk Enclosures
- >
- VA7410 Mismatched Code
Disk Enclosures
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
-
- Forums
-
Blogs
- Alliances
- Around the Storage Block
- Behind the scenes @ Labs
- HPE Careers
- HPE Storage Tech Insiders
- Infrastructure Insights
- Inspiring Progress
- Internet of Things (IoT)
- My Learning Certification
- OEM Solutions
- Servers: The Right Compute
- Shifting to Software-Defined
- Telecom IQ
- Transforming IT
- Infrastructure Solutions German
- L’Avenir de l’IT
- IT e Trasformazione Digitale
- Enterprise Topics
- ИТ для нового стиля бизнеса
- Blogs
-
Quick Links
- Community
- Getting Started
- FAQ
- Ranking Overview
- Rules of Participation
- Contact
- Email us
- Tell us what you think
- Information Libraries
- Integrated Systems
- Networking
- Servers
- Storage
- Other HPE Sites
- Support Center
- Enterprise.nxt
- Marketplace
- Aruba Airheads Community
-
Forums
-
Blogs
-
InformationEnglish
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
07-16-2009 08:24 AM
07-16-2009 08:24 AM
VA7410 Mismatched Code
When I connect serially to the VA7410, the prompt I get is Mismatched Code>
I have tried to display the two controllers with the dsp -d 1/2 and it returns "Controller Not Present". The command dsp -d returns "No disks present" Yet there are 14 disks in the array. I can't seem to figure this out. I have the host port connected to a HP-UX box and when I try to use CommandView armdiscover, I can see the fibre host port blink so it is talking to it but CommandView cannot see it. Any thoughts?
I have tried to display the two controllers with the dsp -d 1/2 and it returns "Controller Not Present". The command dsp -d returns "No disks present" Yet there are 14 disks in the array. I can't seem to figure this out. I have the host port connected to a HP-UX box and when I try to use CommandView armdiscover, I can see the fibre host port blink so it is talking to it but CommandView cannot see it. Any thoughts?
1 REPLY
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
07-16-2009 11:57 PM
07-16-2009 11:57 PM
Re: VA7410 Mismatched Code
Hello,
where did you get this system? Are both controller okay? Did you an firmware update?
Best regards,
Patrick
where did you get this system? Are both controller okay? Did you an firmware update?
Best regards,
Patrick
Best regards,
Patrick
Patrick
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
End of content
United States
Hewlett Packard Enterprise International
Communities
- Communities
- HPE Blogs and Forum
© Copyright 2019 Hewlett Packard Enterprise Development LP