Disk Enclosures
1748151 Members
3552 Online
108758 Solutions
New Discussion юеВ

Re: XCS 5.110 to XCS 6.100 upgrade

 
SOLVED
Go to solution
Jeff_Traigle
Honored Contributor

Re: XCS 5.110 to XCS 6.100 upgrade

After the entries stating the EMU updates were completed, I see a few of these:

An HSV200 controller has processed a Storage System Management Interface command with the result of non-success return code.
Corrective action code: 00

The details are in the attachment.
--
Jeff Traigle
Rob Leadbeater
Honored Contributor
Solution

Re: XCS 5.110 to XCS 6.100 upgrade

Hi,

> How long is "a while"? It's been nearly 1.5 hours.

Normally no more than 10-15 minutes on the EVAs I've done...

> Guess I should also mention this is Command View EVA v9.1

It might be... The compatibility matrix here:

http://bizsupport2.austin.hp.com/bc/docs/support/SupportManual/c01858971/c01858971.pdf

says 9.1 should work, but the little foot note at the bottom of page 5 makes me wonder:

"HP recommends that you upgrade to XCS 6.2xx if you are using HP Command View EVA 8.0.1 or later."

Cheers,

Rob
Niels Vejrup Pedersen
Respected Contributor

Re: XCS 5.110 to XCS 6.100 upgrade

Hello,
Everything with a CAC of 00 means no action should be taken.

As Rob states they recommend going to XCS 6.2xx. But your step to XCS 6.100 was required before going there.

If you got a support contract on the system i would recommend logging a call with HP. Just to check if its safe to upgrade before all the stuff moves from unmappable hardware folder.

Regards
Niels Vejrup Pedersen
Respected Contributor

Re: XCS 5.110 to XCS 6.100 upgrade

Hello,

Did you find a solutions ?

Regards
Jeff_Traigle
Honored Contributor

Re: XCS 5.110 to XCS 6.100 upgrade

I went ahead and did a code load on the disks this morning. They were all incredibly old firmware revisions also. After they were updated, the disk enclosures appeared and no disks are unmappable.
--
Jeff Traigle