- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- Disk Enclosures
- >
- XP256 Command View Difficulty
Disk Enclosures
1753975
Members
7557
Online
108811
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-29-2002 02:11 AM
05-29-2002 02:11 AM
XP256 Command View Difficulty
Hi All
I have a problem implementing Command View for XP256.
The setup is 2 XP256s and a single XP512. The Command View management station is a Windows 2000 Advanced Server which runs Remote Control for XP256 and XP512 as well as CV.
RC works fine for all arrays. CV works correctly on our XP512, but when I attempt to use Device Administration in CV to add the agent IP address for our XP256s (ie, the management station's own IP address) I get a "could not connect to agent" type error.
I think I've followed the install instructions for CV correctly. I have the SNMP and SNMP Trap services running on the CV management station and they're configured with the appropriate community name and trap destination.
Is there something that needs to be done on the SVP of the XP256?
Thanks in advance
Will
I have a problem implementing Command View for XP256.
The setup is 2 XP256s and a single XP512. The Command View management station is a Windows 2000 Advanced Server which runs Remote Control for XP256 and XP512 as well as CV.
RC works fine for all arrays. CV works correctly on our XP512, but when I attempt to use Device Administration in CV to add the agent IP address for our XP256s (ie, the management station's own IP address) I get a "could not connect to agent" type error.
I think I've followed the install instructions for CV correctly. I have the SNMP and SNMP Trap services running on the CV management station and they're configured with the appropriate community name and trap destination.
Is there something that needs to be done on the SVP of the XP256?
Thanks in advance
Will
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP