HPE Community
Disk Enclosures
1752800 Members
5417 Online
108789 Solutions
New Discussion

XP256 Initial setup mode

 
Tim Estes
New Member

‎08-14-2002 11:10 AM

‎08-14-2002 11:10 AM

XP256 Initial setup mode

I have an XP256 system that was reconfigured cold, contains no customer data.
Does anyone know the initial setup mode password? (ctrl+shift+i)
Thanks!
0 Kudos
Reply
1 REPLY 1
Mark van Silfhout
Trusted Contributor

‎08-15-2002 02:27 AM

‎08-15-2002 02:27 AM

Re: XP256 Initial setup mode


Hi Tim,

This password is HP (& Hitachi) only, in fact working on the SVP is for HP engineers only. There's no need for the cu to use the SVP to (re)configure the XP.

Please use CommandView or the Remote Control software to (re)configure.

Best Regards.
Mark van Silfhout
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.