abot hsz70

[leyearn]

I added six disks to the hsz70
>run config
>add raidset r5 disk10300 disk20300 disk30300 disk40300 disk50300 disk60300
>init r5
>create_partition r5 size=50
>create_partition r5 size=largest
>add unit d104 r5 partition=1
>add unit d105 r5 partition=2


11-AUG-1946 16:45:35 (time not set)-- Instance Code: 0328450A
Template: 81.(51)
Power On Time: 6. Years, 37. Days, 9. Hours, 10. Minutes, 56. Seconds
Controller Model: HSZ70
Serial Number: ZG92902720 Hardware Version: H03(49)
Firmware Version: V70Z(70)
Unit Number: 104.(0068)
Unit Software Version: 1.(01) Unit Hardware Version: 54.(36)
Retry Level: 1. Retries: 0.
Port: 2. Target: 3. LUN: 0.
SCSI Device Type: 0.(00)
Device ID: "RZ1CD-CS (C) DEC" Device Serial Number: "LG610516"
Device Firmware Revision Level: "0306"
SCSI Command Opcode: 40.(28)
Sense Data Qualifiers: 128.(80)
SCSI Sense Data:
Error Code: 112.(70) {current command execution}
Information field is valid
Segment: 0.(00)
Sense Key: 1.(01) RECOVERED ERROR
ILI: 0 EOM: 0 FM: 0
Information: C8C80A00
Additional Sense Length: 10.(0A)
Command-Specific Information: 00000000
ASC: 24.(18) ASCQ: 1.(01)
FRU: 234.(EA) Sense-Key Specific: 2D0080
Instance Code: 0328450A
hsz70_1>

what's the meaning of the message?

[Vladimir Fabecic]

See:
Sense Key: 1.(01) RECOVERED ERROR
That probably means that disk
Device ID: "RZ1CD-CS (C) DEC" Device Serial Number: "LG610516"
had some retry in writing data.
That can caused by bad block, some time-out and simular.
Nothing to worry about too much. But if this disk produce many messages like that, it should be replaced.
Regards

[Larry De Clay]

Hi,
Yes, the disk DISK20300 was who logged this error. It´s a recovered error and you have to monitor it if that happen frequently probably you have to replace the disk.

Bye,
Larry