Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
Disk Enclosures
cancel
Showing results for 
Search instead for 
Did you mean: 

adding second hvd10 JBOD

SOLVED
Go to solution
Nick D'Angelo
Super Advisor

adding second hvd10 JBOD

All,

We currently have one HVD10 JBOD and we want to add a second.

I have two controllers on my server that presently goes from port a on the controller to port a on the back of the jobd and same for B.

DIP switches are set as follows: 1 off (down) 2-5 on (UP)

If I want to daisy chain my second JBOD, do I just continue Port a on HVD 1 to Port A on HVD2? and terminate on HVD 2?

Do I also set the dip switches the same or differently?

Thanks.
Always learning
1 REPLY
Torsten.
Acclaimed Contributor
Solution

Re: adding second hvd10 JBOD

You need to configure split bus. So you can daisy chain a half HVD10 to another half box.

This link is yours:

http://h20000.www2.hp.com/bc/docs/support/SupportManual/lpg28482/lpg28482.pdf

HP Surestore E disk system HVD10 - User and Service Guide

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!