Disk Enclosures
cancel
Showing results for 
Search instead for 
Did you mean: 

card dead after upgrade

Ayman Altounji
Valued Contributor

card dead after upgrade

Hello,

after upgrading the card (Compaq SMART-2 Array Controller) with rompaq version 3.09.02 i got the message that the upgrade was not succesfull. After reboot i got following error message

1783 - array controller failure
command failure (cmd=11h:err=0BEh)
1 REPLY
Ayman Altounji
Valued Contributor

Re: card dead after upgrade

Hi, When the upgrade was not successful that mean the array controller is failed. You could try back previous version by putting a /x with a space in front at the end of the Shell command in the config file on flash disk but I still think there is nothing else than to replace the array controller.