HPE Community
Disk Enclosures
1752794 Members
6147 Online
108789 Solutions
New Discussion

card dead after upgrade

 
Ayman Altounji
Valued Contributor

‎09-26-2002 04:00 PM

‎09-26-2002 04:00 PM

card dead after upgrade

Hello,

after upgrading the card (Compaq SMART-2 Array Controller) with rompaq version 3.09.02 i got the message that the upgrade was not succesfull. After reboot i got following error message

1783 - array controller failure
command failure (cmd=11h:err=0BEh)
0 Kudos
Reply
1 REPLY 1
Ayman Altounji
Valued Contributor

‎09-30-2002 04:00 PM

‎09-30-2002 04:00 PM

Re: card dead after upgrade

Hi, When the upgrade was not successful that mean the array controller is failed. You could try back previous version by putting a /x with a space in front at the end of the Shell command in the config file on flash disk but I still think there is nothing else than to replace the array controller.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.