- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- Disk Enclosures
- >
- error from dmesg output observed on 12H
Disk Enclosures
1752413
Members
5774
Online
108788
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-04-2001 02:54 AM
12-04-2001 02:54 AM
error from dmesg output observed on 12H
hi all ... can somebody tell wat this error means in my dmesg output on node1 of a two node cluster sharing a 12H autoraid box.las ttime i got same sort of errors and a file system use to respond "i/o error"for bdf command.then i did a thorough Preventive Maintenance.this problem didnt repeat after that.but now similar error is there but there are no i/o errors..help pls...
regard
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-04-2001 05:06 AM
12-04-2001 05:06 AM
Re: error from dmesg output observed on 12H
It means than the path was switched from the primary controller X to Y on your 12H. The most common reason for this is using the default IO timeout on the physical disk. Do a pvdisplay /dev/dsk/cXtYdZ and note the IO Timeout value. If it is default (or less than 120 seconds) use pvchange to set it to at least 120 seconds. Somewhere in the range of 120-180 seconds is good. You should set the value on all the LUN's in your 12H.
Man pvdisplay, pvchange for details.
Clay
Man pvdisplay, pvchange for details.
Clay
If it ain't broke, I can fix that.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP