HPE Community
Disk Enclosures
1752653 Members
5352 Online
108788 Solutions
New Discussion

have a VA7400, replaced disk at M/D5

 
SOLVED
Go to solution
Dean Carroll
Occasional Advisor

‎03-19-2009 11:54 AM

‎03-19-2009 11:54 AM

have a VA7400, replaced disk at M/D5

I have a VA7400 that had a drive fail. The drive has been replaced (M/D5). The Disk State is "Previously used" and the redundancy group doesn't look valid. How can I get this drive recognized and used by the VA7400 and get rid of the Warnings at the end of the armdsp -a output?
0 Kudos
Reply
1 REPLY 1
Torsten.
Acclaimed Contributor

‎03-19-2009 09:00 PM

‎03-19-2009 09:00 PM

Solution

Re: have a VA7400, replaced disk at M/D5

Hi Dean,

this disk was in another VA before.

You need to include it manually using the arm command.

IIRC this would be

armcfg -D M/D5 -a myArray

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.