Community
Disk Enclosures
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

how can I re-enable my logical drive on smart 2dh controller

 
Recycle-Michael
Recycle-Michael
Occasional Visitor

‎05-17-2010 07:50 AM

‎05-17-2010 07:50 AM

how can I re-enable my logical drive on smart 2dh controller

I have a Proliant ML370 with a 2DH controller. a 6 drive array internal which works fine, and a 5 drive array in an enclosure (it is a 7 drive enclosure, but I only have 5 drives in it).
All was working fine, when two days ago I accidentally disconnected the scsi connector cable to the enclosure, and reconnected it immediately after upon realizing this.

Upon cold reboot, the controller sees the first array but not the external one. When I use Compaq ACU it tells me that I have 5 drives that are unassigned.

I researched and notice that the HPACUCLI might allow me to re-enable this array, but I am using W2k (sp4) and I cannot seem to be able to install this utility. I initially set this server up with Smart Start 5.10 and I tried to install HPACUCLI from a Smart Start 7.1 but to no avail.

Help from anyone would be greatly appreciated! Thank You Michael
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.