HPE Community
Disk Enclosures
1753779 Members
7535 Online
108799 Solutions
New Discussion

management authorization

 
Barry Lee Ling_1
New Member

‎07-30-2002 05:16 AM

‎07-30-2002 05:16 AM

management authorization

I recently changed the memory for an HP9000 K260 from 2GB to 1GB by swapping the memory carrier with that of another K260 which was 1GB. The K260 is connected to a 12H autoRAID array and I now get this message in syslog:
"Management Authorization to HP Array 000..BF2 succeeded for Userid: root"
Can anyone tell me what this means?
0 Kudos
Reply
1 REPLY 1
Bill McNAMARA_1
Honored Contributor

‎08-01-2002 01:56 AM

‎08-01-2002 01:56 AM

Re: management authorization

Are your sure it wasn't there before.. changing memory should be unrelated..
Sounds like the ARMServer starting up or accepting a command request, but I wouldn't see it as a concern at all, in fact I'd see it as a benefit.

Later,
Bill
It works for me (tm)
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.