Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
Disk Enclosures
cancel
Showing results for 
Search instead for 
Did you mean: 

modify Array configuration: RAID0 to RAID1 and add a disk

Franck L
Occasional Visitor

modify Array configuration: RAID0 to RAID1 and add a disk

A server as been very bad install:
this server contain 2 hard drive and a E200i Smart ary controller.

Normally, disk configuration is a mirroring.
But a technician has create a RAID 0 with only 1 harddisk...
The other harddisk is unassigned.
You can show configuration in attachment.

Is there possible to modify this configuration to a raid 1 and to add the unassigned harddisk to the raid without a lost of data ?


Apparently, it is impossible with the GUI.
But I have found all needed command in the ACU CLI:
ctrl slot=1 logicaldrive 1 modify raid=1 stripesize=default
ctrl slot=1 logicaldrive 1 add drive=2

Are those 2 commands my solution ?

Thanks in advance.

FL
2 REPLIES
marsh_1
Honored Contributor

Re: modify Array configuration: RAID0 to RAID1 and add a disk

franck,

the e200 does support raid migration so that should work ok, but please do a backup before you start ! :-)

hope this helps

Franck L
Occasional Visitor

Re: modify Array configuration: RAID0 to RAID1 and add a disk

Sure

thanks for your help !