Disk Enclosures
cancel
Showing results for 
Search instead for 
Did you mean: 

what is the good command to verify load balance on securepath sp3

Hanry Zhou
Super Advisor

what is the good command to verify load balance on securepath sp3

Thanks,
none
3 REPLIES
Torsten.
Acclaimed Contributor

Re: what is the good command to verify load balance on securepath sp3

I did not work so much with this, but I would try

# spmgr display

first.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Denver Osborn
Honored Contributor

Re: what is the good command to verify load balance on securepath sp3

autopath display

Look for "Load Balancing Policy"

To set the load balance policy for round robin...

"autopath set_lbpolicy RR /dev/dsk/cXtXdX"

man autopath for details.

If you want to test and see that it's balancing among all configured paths, you could run a dd to read from one device then pull up 'glance -u' to verify it's spread across all the paths

-denver
Steven E. Protter
Exalted Contributor

Re: what is the good command to verify load balance on securepath sp3

Shalom,

by disk check the sar commands related to disk and buffers

http://www.hpux.ws/?p=6

SEP
Steven E Protter
Owner of ISN Corporation
http://isnamerica.com
http://hpuxconsulting.com
Sponsor: http://hpux.ws
Twitter: http://twitter.com/hpuxlinux
Founder http://newdatacloud.com