Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
Disk Enclosures
cancel
Showing results for 
Search instead for 
Did you mean: 

what need to be modified in CommandView EVA when replacing HBA?

SOLVED
Go to solution
stephen peng
Valued Contributor

what need to be modified in CommandView EVA when replacing HBA?

Guys,
I need to replace an HBA which connect a rp7420 to the SAN which eva4000 is in. I want to know how to update the host's WWN information in CommandView EVA so that host could access the eva4000 with new HBA.

regards
Stephen
3 REPLIES
Torsten.
Acclaimed Contributor
Solution

Re: what need to be modified in CommandView EVA when replacing HBA?

Replace the HBA and use "fcmsutil" to get the new WWN.

Then go to command view and adjust the host section.

Find the old HBA WWN and replace it by the new WWN.

If you doing WWN based zoning on the switch, you need to adjust there too.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
stephen peng
Valued Contributor

Re: what need to be modified in CommandView EVA when replacing HBA?

Torsten,
from which user guide I could get the detailed guideline?

regards
Stephen
Torsten.
Acclaimed Contributor

Re: what need to be modified in CommandView EVA when replacing HBA?

Maybe from the command view guide and regarding the zoning from the switch manual.

But in fact this is not this hard.

In CV hosts section just delete the old port (old HBA) and add the new.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!