Community
Disk
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Re: One part number, but different disks' model.

 
PaWeLL
Occasional Contributor

‎07-20-2015 01:51 AM

‎07-20-2015 01:51 AM

One part number, but different disks' model.

Hello.  Recently we've got 12 HP 300G SAS 15k disks with pn - 652611-B21.  9 of them are EH0300FCBVC, but 3 are EH0300FBQDD. Is this situation OK? And now bothering about compatibility between this disks in one raid array. Should I re-build arrays until it was too late?

0 Kudos
2 REPLIES 2
AnkitM
Trusted Contributor

‎07-20-2015 03:11 AM

‎07-20-2015 03:11 AM

Re: One part number, but different disks' model.

Yes, it is competely normal.

 

Difference between EH0300FBQDD and EH0300FCBVC would be different manufacturer or the release.

 

However, the drive specs are the same: 300GB hot-plug dual-port SAS hard disk drive - 15,000 RPM, 6Gb/sec transfer rate, 2.5-inch small form factor (SFF), Enterprise, SmartDrive Carrier (SC) which is more important.

Was your question answered correctly? If so, please remember to mark your question Answered when you get the correct answer and award KUDOS! to the person providing the answer. This helps others searching for a similar issue.
PaWeLL
Occasional Contributor

‎11-15-2015 04:10 AM

‎11-15-2015 04:10 AM

Re: One part number, but different disks' model.

Ok, but how about different firmware version? I've heard that drives in RAID should be identical, and different FW versions on drives makes me frustrating. 

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.