Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
EVA Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

MSA 2312fc wrong enclosure ID

sam bell
Regular Advisor

MSA 2312fc wrong enclosure ID

Hi,

 

I've just added a second MSA2000 dual IO enclosure to a MSA2312fc dual controller (currently with only one I/O module connected). Usually the new enclosure should have ID 2, however, it is shown as enclosure ID 3.

 

I've already performed a disk channel rescan but this didn't change anything. Does anybody know how the wrong enclosure ID can be corrected?


Thanks

 

 

 

 

 

 

 

7 REPLIES
Sudhakar Subramaniam
Trusted Contributor

Re: MSA 2312fc wrong enclosure ID

Please refer the below PDF for cabling diagram which should resolve the issue

 

http://h10032.www1.hp.com/ctg/Manual/c01755933.pdf

sam bell
Regular Advisor

Re: MSA 2312fc wrong enclosure ID

Thanks, the cabling looks fine to me? Ctrl A is connected to IO module A. Or is this because I only have one IO module connected?

Johan Guldmyr
Honored Contributor

Re: MSA 2312fc wrong enclosure ID

Would this cause any issues?
sam bell
Regular Advisor

Re: MSA 2312fc wrong enclosure ID

I don't think so, but it bugs me that it is not correct. But if it is not possible to correct - I guess I'll have to live with it. Thanks.

SUBHAJIT KHANBARMAN_1
Respected Contributor

Re: MSA 2312fc wrong enclosure ID

Try the following,

 

To rescan using SMU, as an Advanced Manage user:

Select Manage > Utilities > Disk Drive Utilities > Rescan.

In the Rescan For Devices panel, click Rescan.

It can take up to two minutes for the enclosure IDs to be corrected.

SUBHAJIT KHANBARMAN_1
Respected Contributor

Re: MSA 2312fc wrong enclosure ID

Ignore my last post.

 

I hope you have already tried disk channel scan but no go.

 

May be controller restart or the power cycle the array may help.

Johan Guldmyr
Honored Contributor

Re: MSA 2312fc wrong enclosure ID

Where is this enclosure ID stored?
How and when is it selected?