Problem to connect MDS9222i to EVA6100 and MSL6030

[Seyed Ali]

Hi
i have one cisco MDS9222i switch (this switch is factory default config with enabled port) and i want to connect EVA 6100 controller, command view eva management server and MSL6030 fibrechannel tape to this switch.after connect these devices to switch, i saw on switch connected status ports are on and F port detected.
My problem is:
CV server can not see MSL and EVA controller when it is connected to MDS9222i
but when i connect MSL or EVA directly to management server, it can detect successfully.Also i test with another switch
(HP STORAGEWORKS 4/8) and connect management server,EVA controller and MSL to this switch. result was successfully and i could see EVA and MSL when my devices connected to HP switch.
i want to know what is problem when these devices connected to MDS9222i?
i saw comaptibility matrix but i couldnt find EVA 6100 and MDS9222i to check compatibility. please help me

[Bhavnish Kamboj (BK) · Accepted solution]

Have you done any zoning on Cisco switch? The reason on brocade switch (4/8) you are able to see could be because of zoning or switch may be running in open zone (means all devices can see each other)

For compatibilty matrix you may go to below link:

http://h20272.www2.hp.com/

Thanks,
BK

[Seyed Ali]

Thank you for your help
after configuring zoning problem solved