EVA Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

Problem to connect MDS9222i to EVA6100 and MSL6030

 
SOLVED
Go to solution
Seyed Ali
Occasional Advisor

Problem to connect MDS9222i to EVA6100 and MSL6030

Hi
i have one cisco MDS9222i switch (this switch is factory default config with enabled port) and i want to connect EVA 6100 controller, command view eva management server and MSL6030 fibrechannel tape to this switch.after connect these devices to switch, i saw on switch connected status ports are on and F port detected.
My problem is:
CV server can not see MSL and EVA controller when it is connected to MDS9222i
but when i connect MSL or EVA directly to management server, it can detect successfully.Also i test with another switch
(HP STORAGEWORKS 4/8) and connect management server,EVA controller and MSL to this switch. result was successfully and i could see EVA and MSL when my devices connected to HP switch.
i want to know what is problem when these devices connected to MDS9222i?
i saw comaptibility matrix but i couldnt find EVA 6100 and MDS9222i to check compatibility. please help me
2 REPLIES 2
Bhavnish Kamboj (BK)
Trusted Contributor
Solution

Re: Problem to connect MDS9222i to EVA6100 and MSL6030

Have you done any zoning on Cisco switch? The reason on brocade switch (4/8) you are able to see could be because of zoning or switch may be running in open zone (means all devices can see each other)

For compatibilty matrix you may go to below link:

http://h20272.www2.hp.com/

Thanks,
BK
Highlighted
Seyed Ali
Occasional Advisor

Re: Problem to connect MDS9222i to EVA6100 and MSL6030

Thank you for your help
after configuring zoning problem solved