SAN Switch configuration problem

[albert1]

Hello ! 

I have a HP storage Work 8/24 SAN Switch  (AM868A)  !!

I want to config this switch in the simplest way possibe (without Command Line Interface ) !!

What can i do ??????

Pls Help me ! this is emergency !!!!!!

Thanks for your support !!!!

[Sheldon Smith]

If you have the current Java runtime installed on your desktop, you can simply browse to the switch using its IP address. The switch's WebTools should start and prompt you for your username (normally "admin") and the corresponding password.

Note: While I work for HP, all of my comments (whether noted or not), are my own and are not any official representation of the company.
----------
If my post was useful, click on my KUDOS! thumb below!

[AnkitM]

While you are using WebTools, you may refer: http://www.brocade.com/downloads/documents/product_manuals/B_SAN/WebTools_AdminGd_v720.pdf for How To's and Steps.

[albert1]

thanks for your help !!!!!!

What is the default IP address , Username and password     ??????

[Torsten.]

see for example

http://h30499.www3.hp.com/t5/Switches-Hubs-Modems-Legacy-ITRC/How-to-configure-HP-StorageWorks-8-24-SAN-Switch/td-p/4562774#.VXAUBUbQpHU

...

default ip-address is 10.77.77.77. Default username and password is "admin" and "password".

...

a new switch usually comes with an installation flyer with first steps.

IMHO you better connect the serial cable, log on (9600 baud) and type

swd77:admin> ipaddrset