3com U.S Robotics ISDN TA in Linux

[Muhammad Imran Hussain]

hello all members

I've 3com U.S Robotics ISDN TA & i want it to connect to internet on my Linux box. I use RH 7.3 & 8.0. when i dial through Kppp it connects on 64000 but i've 128K account, but in MS W2K it connect on 128K & runs fine, somebody suggest me to increase speed in KPPP modem speed option but still the same problem.
what do i do with this plz give me suggestions.
i 'm using RS232 interface.

[Jerome Henry]

See my reply on networking section !

Yours

J

[Muhammad Imran Hussain]

hi

i can't find where in networking section

[Jerome Henry · Accepted solution]

Ok, I'm re-posting it (seems it posted but it didn't go thru).

When you open and ISDN connection, you open 1 or 2 channels, each of 64 k. Increasing modem speed wont' resolve things, what you have to set up is to use 2 channels instead of one...

User under rh8 hat / system settings /network device control, and add a new interace, which will be your isdn adapter, and chekc to use both B channels.
Here is Red Hat tip on this :
http://www.europe.redhat.com/documentation/rhl8.0/rhl-cg-en-8.0/s1-network-config-isdn.php3

Once you've done it, select this interface in your kppp connection, it should work.

hth
J

[Muhammad Imran Hussain]

hi

i tried but it's only connect on 64Kbit
i cheked it with downloading, the download rate is max 8K.

what do i do

[Jerome Henry]

Hi,

In your kppp, what is connection speed ?

Run 'network device configuration' select you isdn device, click 'configure', go to 'advanced' and check that 'Use channel assembler' is selected.

hth

J

[Muhammad Imran Hussain]

hello

the connection speed is set to 115200 in kppp.

My modem is not appear in ISDN adapter list therefore i add as modem not ISDN in the Network device control option

[Muhammad Imran Hussain]

hello

Linux detects my ISDN TA but it not shows in ISDN device list

[Jerome Henry]

That's why it doesn't open 2 channels, as modems can open only one.

Try to add values by yourself, selecting another US robotics device, under isdn section, it's quite standard values. But in my RH9 box, us robotics is seen in the list... maybe try to download from us robotics site a driver if you don't succeed.

J

[Muhammad Imran Hussain]

hello

congratulations u deserve it & thank u for ur co-operation with me.
There is no device like my TA in the list of ISDN devices