HPE Community
BladeSystem - General
1752672 Members
6197 Online
108789 Solutions
New Discussion

C3000 and port mapping

 
Gavin_30
Regular Advisor

‎06-28-2017 07:41 AM - edited ‎06-28-2017 07:44 AM

‎06-28-2017 07:41 AM - edited ‎06-28-2017 07:44 AM

C3000 and port mapping

Hi please assist,

 

I have a c3000 enclosure with VC flex 10 in interconnect bay 1 and 2. Im using BL460 G9 half height blades

My server has onboad flb560 and 560M mezz card.

With this config I can only seem to get 4 x NICS that map through, any additional NICS assigned in profile just give unmapped error.

NIC 1 and 2 map to LOM and NIC 3 and $ to Mezz.

 

Is this correct?

 

 

 

 

0 Kudos
Reply
1 REPLY 1
peyrache
Respected Contributor

‎06-28-2017 07:49 AM

‎06-28-2017 07:49 AM

Re: C3000 and port mapping

Right
JY
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.